This makes eth_call and eth_estimateGas use the zero address
as sender when the "from" parameter is not supplied.
Co-authored-by: Felix Lange <fjl@twurst.com>
This removes the error added in #20597 in favor of a log message at
error level. Failing to start broke a bunch of people's setups and is
probably not the right thing to do for this check.
This adds additional logic to re-resolve the root name of a tree when a
couple of leaf requests have failed. We need this change to avoid
getting into a failure state where leaf requests keep failing for half
an hour when the tree has been updated.
* node: expose config in service context
* eth: integrate p2p/dnsdisc
* cmd/geth: add some DNS flags
* eth: remove DNS URLs
* cmd/utils: configure DNS names for testnets
* params: update DNS URLs
* cmd/geth: configure mainnet DNS
* cmd/utils: rename DNS flag and fix flag processing
* cmd/utils: remove debug print
* node: fix test
* p2p: new dial scheduler
This change replaces the peer-to-peer dial scheduler with a new and
improved implementation. The new code is better than the previous
implementation in two key aspects:
- The time between discovery of a node and dialing that node is
significantly lower in the new version. The old dialState kept
a buffer of nodes and launched a task to refill it whenever the buffer
became empty. This worked well with the discovery interface we used to
have, but doesn't really work with the new iterator-based discovery
API.
- Selection of static dial candidates (created by Server.AddPeer or
through static-nodes.json) performs much better for large amounts of
static peers. Connections to static nodes are now limited like dynanic
dials and can no longer overstep MaxPeers or the dial ratio.
* p2p/simulations/adapters: adapt to new NodeDialer interface
* p2p: re-add check for self in checkDial
* p2p: remove peersetCh
* p2p: allow static dials when discovery is disabled
* p2p: add test for dialScheduler.removeStatic
* p2p: remove blank line
* p2p: fix documentation of maxDialPeers
* p2p: change "ok" to "added" in static node log
* p2p: improve dialTask docs
Also increase log level for "Can't resolve node"
* p2p: ensure dial resolver is truly nil without discovery
* p2p: add "looking for peers" log message
* p2p: clean up Server.run comments
* p2p: fix maxDialedConns for maxpeers < dialRatio
Always allocate at least one dial slot unless dialing is disabled using
NoDial or MaxPeers == 0. Most importantly, this fixes MaxPeers == 1 to
dedicate the sole slot to dialing instead of listening.
* p2p: fix RemovePeer to disconnect the peer again
Also make RemovePeer synchronous and add a test.
* p2p: remove "Connection set up" log message
* p2p: clean up connection logging
We previously logged outgoing connection failures up to three times.
- in SetupConn() as "Setting up connection failed addr=..."
- in setupConn() with an error-specific message and "id=... addr=..."
- in dial() as "Dial error task=..."
This commit ensures a single log message is emitted per failure and adds
"id=... addr=... conn=..." everywhere (id= omitted when the ID isn't
known yet).
Also avoid printing a log message when a static dial fails but can't be
resolved because discv4 is disabled. The light client hit this case all
the time, increasing the message count to four lines per failed
connection.
* p2p: document that RemovePeer blocks
